Step 1: Prepare The Windows For Tinting
You should clear all things on the glass and apply soapy water on the glass. Scrape out any mess with the help of a blade. Now dry the glass. You may use a microfiber towel and squeegee to check for wet surfaces.
Marginally, lower the windows as this will help you with clearing all parts of glass and after that move it upwards. Now get ready for a spray bottle which should be filled with the soap water solution.
Step 2: Cut Out The Window Tint Film
For beginners, it might help you don’t use your window as a guide. Instead, whip out cardboard and cut out a template for the car window. After doing that , you can get a window shape as perfect and avoid any wastage of film.
By mistake if you cut the wrong shape, you can easily produce another template. Presently, add 3/4 of an inch to the lower part of the seal. Then, at that point, let the quarter of inch go to the top and sides of the seals. Subsequent to finishing the layout, place it with the film on a sturdy surface.Then, at that point, with the help of a knife cut the edges of the material so it will have a similar shape as the template..
Now, you ought to have an outline that matches the window of the vehicle. However, confirm you have the right size by putting it on the glass.
Step 3: Fix The Film On The Glass
Subsequent to getting the right film size for the window, use a squeegee or spray bottle to add some application of fluid. Then, at that point, eliminate the external layer of the film and place fluid on the tacky end.
When the adhesive end of the film responds to pressure, utilize less power, and avoid creases and bubbles. With the help of excess pressure on the film, the film will in general stick to the glass. If you have any issue, you should begin from the start.
With the film ready, take the squeegee and push the tint on the glass. For this assignment, have a go at going with even strokes that begin from the middle and move outwards. However, prior to using any tool, lubricate with the soap solution.
Keep applying the soapy water while stroking the air bubbles and application fluid from under the film. You ought to keep up with less pressure and don't change the direction of the squeegee. When you remove the solution from the Window Tint, this will bond with the window.
Remember the edges and corners of the windows. To arrive at these tight spots, cut a piece of one more squeegee and make the film to adjust to the center and corners.
After doing the above steps you should leave the film to bond totally with the glass. After 48 hours, you can wind down the glass or clean it.
No comments yet