The MSRM US750 Extender setup is very easy. Simply place it in a power outlet that is connected to your current WiFi network. Join the network of the extender, use the default IP address to reach the setup page in your browser, and then follow the on-screen directions to join your home WiFi. After it's finished, take advantage of wider WiFi coverage in your house or place of business.

MSRM US750 WiFi Extender Setup Manually

• Apply power to the MSRM US750 Extender by plugging it in.

• Link your device to the extender's network.

• Open a web browser and type in the given IP address by default.

• For the username and password, use the normal settings.

• To choose your home WiFi network, follow the on-screen directions.

• When prompted, enter the WiFi password.
• For best coverage, move the extender once it's connected.

MSRM US750 WiFi Range Extender Setup WPS

• Close to your router, plug in the MSRM US750 Extender.

• The WPS button on the extender should be pressed.

• Press the WPS button for 2 minutes.

• Wait for the extender's WPS indicator to light up to verify the connection.
• If required, move the extender to provide the best possible coverage.
• Enjoy increased WiFi coverage without extra setup.

NOTE : If you need any help regarding your wavelink wifi range extender so get in touch with the technician or visit the official web site that is wavlink wifi extender setup

MSRM US750 Extender Login

• Join the WiFi network of the MSRM US750 Extender.

• On your device, open a web browser.

• In the address bar, type "192.168.0.1."

• Enter the default password and username, which are typically "admin" for each.

• To log in, press Enter.
• Now that you're signed in, you can change the settings of your extender as required.

Firmware Update MSRM US750 Extender

• Link the device to the WiFi network of the MSRM US750 Extender.

• Put  ap setup "192.168.0.1" into the address bar of an open web browser.

• Enter your password and username to log in.

• Find the settings menu's "Firmware Update" section.

• To download and install the most recent firmware, follow the on-screen directions.
• Wait for the extension's reboot and the end of the improvement process.

MSRM US750 Reset Process

• Find the MSRM US750 Extender's reset button.

• Hold down the reset button for approximately ten seconds.

• When the extender's lights begin to flash, release the reset button.

• Hold out for the extender's factory reset to take place.

• Change the settings on your extender as needed.