Top 5 Ricoma CHT2 Series Common Error?
Popular commercial embroidery machine line is the Ricoma CHT2 Series. Although the device is typically dependable, users could run across several common errors that could affect their embroidered projects.
The Ricoma CHT2 Series is a well-known commercial embroidery machine series. The following are some of the most typical mistakes that users may face when using the machine:
Table of Content:
- Thread Break Troubleshooting:
- Bobbin Running Out:
- No Needle Error Or Color Change Error:
- Motor Fault Or Main Axis Error:
- Tension:
More Detail Visit: Top 5 Ricoma CHT2 Series Common Error
1. Thread Break Troubleshooting:
There are several reasons why you might be facing frequent thread breaks. To make sure it is not a technical problem, follow these steps:
- Check the thread path to ensure your machine is rightly threaded. It must follow the right path.
- Ensure your thread tension is right. Tight tension might lead to missed stitches, pulling, puckering, thread breaks, and thread stress. On the other hand, loose tension would cause the thread to loop and pile up.
- Check the position of the needle to decide if an actual thread break has happened. Because sometimes the machine reads a thread break, but the thread is still linked to the material. If this is the scenario, check all the thread pathways. Then, do a manual trim and check the supply of the bobbin. If the thread is broken, follow the right thread path and rethread the needle.
- Ensure the thread you are utilizing is not defective. If it is, pull out several yards of thread unless you get rid of the defective thread. If that does not work, try changing the thread with a new one.
- Check for defective needles or needles not placed rightly. You would be capable of telling if a needle is defective or not placed correctly by verifying if the issue is on one or some needles and not others. Change any damaged or twisted needles.
- Ensure the bobbin is installed correctly. Remove any fuzz or dirt build-up in the bobbin case. Ensure the thread trimmer knife is completely pulled back.
- If thread breaks are happening on every needle, you have to adjust the hook timing.
2. Bobbin Running Out:
If the bobbin thread runs out, the machine would automatically stop and a thread break alert will appear on the embroidery status icon. To distinguish a thread break from the bobbin running out, have a look at the thread from the working needle. If it is still linked to the material, it means the bobbin ran out of thread or there is a problem with the bobbin thread. To resolve this, remove the bobbin from the bobbin case. Change it with a new bobbin, and then put the bobbin case back in the rotary hook.
3. No Needle Error Or Color Change Error:
The machine has to be aligned to a hundred degrees to function properly. The main axis is not at a hundred degrees error means that the main axis is not lined up to hundred degrees which is the right position for the machine to begin and stop sewing. This error could be caused if a needle hits the hoop If you get a bird’s nest and other causes. If you get this error, clear the message by pressing “OK”. Then ensure there is a working needle from one to fifteen displayed on the icon. Now turn off the machine. On the left side of your machine, you will see 2 small openings. On one, you will see that the degree of the machine is aligned, and on the other, you will see an Allen head screw. Place the Allen wrench into the Allen head screw and rotate it in a counterclockwise direction until the number shows a hundred degrees again.
Now you can turn on the machine. When the panel shows the main menu screen, press the hundred-degree button on your panel. Now the machine would be all set to embroider.
No comments yet