Netgear EAX80 setup

The Netgear EAX80 setup to your router and a power source for setup. Turn on the device, navigate to the setup page in a web browser using the IP address that was supplied, and log in using the default credentials. To setup Wi-Fi settings, follow the on-screen instructions, save the changes, and then wait for the EAX80 to apply the configuration. You’re done when you connect your devices to the expanded Wi-Fi network. See the handbook for specific information.

How to setup Netgear EAX80 setup manually?

How to manually configure a Netgear EAX80:

• Use an Ethernet wire to connect it to the power source and your router.
• Turn the gadget on.
• Using the supplied IP address, open the setup page in a web browser.
• Use the default login information.
• Adjust the Wi-Fi configuration.
• After making adjustments, save them and join devices to the larger Wi-Fi network.

How do I connect my Netgear EAX80 range extender with WPS?

• Turn on the Netgear EAX80 range extender by plugging it in and turning it on.
• On your EAX80, look for the WPS button. It may be on the side or rear of the extension and is usually labeled.
•  Press and hold the Netgear EAX80’s WPS button until the WPS LED begins to blink.
• Press the WPS button on your primary router within two minutes. A connection will be made between the router and the extension.
• In order to verify a successful connection, watch for the EAX80’s WPS LED to solidify. Right now, your router and extension are coupled.

Note:- If you need any assistance regarding your Netgear EAX80 wifi extender so contact our technician or visit the official website that is mywifiexthelp

Why can’t I log into my NETGEAR EAX80 extender?

In order to access your Netgear EAX80:

• Link to the EAX80 using a gadget.
• Launch a web browser and type the IP address of the EAX80, for example, http://192.168.1.1.
• Utilize the default login information (password: password, username: admin).
• To access the settings, log in.

Note: After logging in, think about changing the default password for security reasons.

How do I update my Netgear EAX80 extender firmware?

To upgrade the firmware on your Netgear EAX80 extender:

• Connect to the network of EAX80.
• Launch a web browser and type http://192.168.1.1 into it to find the extender’s IP address.
• Enter your login information to log in.
• Check the settings for any firmware upgrades.
• To finish updating the firmware, adhere to the on-screen directions if one is available.
• Make sure your internet connection is steady while you update.

How do I reset my EAX80?

For the Netgear EAX80 to be reset:

• Find the extender’s reset button.
• Press and hold the reset button using a paperclip or other similar implement.
• When the power LED begins to blink, hold down the button for five to ten seconds.
• Give the reset button a release.
• The extender will return to factory settings if you wait for it to reboot.