Wavlink wireless range extender connects to your router wirelessly. You can use the WiFi Repeater to extend the wireless coverage and improve the signal strength of your existing wireless network. wavlink extender setup is very easy and quick. Check the steps below:
Step 1 Wavlink Extender Login
Wavlink wifi extender login is a process where you’re required to enter the Wavlink username and password to access its web interface. To do this, you need to follow the steps below:
- Power on your router by pressing the power button on its front panel
- Wait for 30 seconds until it boots up
- Connect via Ethernet cable directly into your modem or use an Ethernet cable as a bridge between your modem/router and Wavlink extender (if required). Make sure that both of them are connected to the same power source so that they can communicate with each other properly
- Open any web browser like Chrome or Firefox on any computer connected through a WiFi network for wavlink extender login.
Step 2: Wavlink Configuration
Once you have finished the above steps, all that's left is signing into its built-in web interface using any browser of your choice. The default username here is "admin" while the password should be left blank. From here, enter the extender settings page where you can configure most of its features such as network name (SSID), security type (WPA2 PSK), channel selection, channel widths for dual-band operation mode, etc.
Step 3: Wifi.wavlink.com
If you want to set up your Wavlink extender, you can visit the website. There, you will find a page where you can easily access all of the information about your Wavlink extender. You will also be able to do things like check the status of your device or update its firmware if needed and also read about wavlink router setup.
No comments yet